| A-3 Manual Transmissions Sample Practice Test |
2. A chirping or squeaking sound is heard
when the clutch pedal is depressed.
All of these could make this noise except the :
when the clutch pedal is depressed.
All of these could make this noise except the :
6. Technician A says the collapsible sleeve may
be loosened to achieve proper pinion bearing
preload. Technician B says an inch pound torque
wrench is used to check pinion bearing preload.
Who's correct?
be loosened to achieve proper pinion bearing
preload. Technician B says an inch pound torque
wrench is used to check pinion bearing preload.
Who's correct?
4. Two technicians are discussing flywheel
resurfacing. Technician A says a mark should
be placed on the flywheel/crankshaft before
removal. Technician B says if too much of the
surface is removed from the flywheel damage
will occur to the release bearing.
Who's correct?
resurfacing. Technician A says a mark should
be placed on the flywheel/crankshaft before
removal. Technician B says if too much of the
surface is removed from the flywheel damage
will occur to the release bearing.
Who's correct?
5. Technician A says a technician may
replace the ring gear with out replacing the
pinion gear as long as the pinion gear checks
out within specifications. Technician B says
that ring gear run out is checked with a digital
micrometer. Who's correct?
replace the ring gear with out replacing the
pinion gear as long as the pinion gear checks
out within specifications. Technician B says
that ring gear run out is checked with a digital
micrometer. Who's correct?
3. Technician A says you should use a feeler
gauge to check the clearance between the
shift fork and the synchronizer sleeve.
Technician B says a bent shift rail could
cause hard shifting. Who's correct?
gauge to check the clearance between the
shift fork and the synchronizer sleeve.
Technician B says a bent shift rail could
cause hard shifting. Who's correct?
8. Limited slip differentials have all of the
following characteristics except:
following characteristics except:
7. Two technicians are discussing axle shafts.
Technician A says that repeated axle seal failure
could be caused by a pitted axle slip yolk.
Technician B says a bent axle could cause axle
seal leakage. Who's correct?
Technician A says that repeated axle seal failure
could be caused by a pitted axle slip yolk.
Technician B says a bent axle could cause axle
seal leakage. Who's correct?
9. A Front Wheel Drive vehicle makes a clicking
sound when cornering. Technician A says this
could be caused by the axles CV Joint.
Technician B says it's the wheel bearing. Who's
correct?
sound when cornering. Technician A says this
could be caused by the axles CV Joint.
Technician B says it's the wheel bearing. Who's
correct?
10. The backup lights of a vehicle are
inoperative. Technician A says the backup switch
may be stuck closed. Technician B says there
may be a loose ground connection. Who's
correct?
inoperative. Technician A says the backup switch
may be stuck closed. Technician B says there
may be a loose ground connection. Who's
correct?
| Free A.S.E. Study Guide An ASE Study Guide for the Automotive Technician |
® All Rights Reserved
© Copyright 2008
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |  |  |  |
1. There is an excessive vibration in a rear
wheel drive vehicle while driving at highway
speeds. Technician A says it could be bad U-
joints. Technician B says it could be out of
balance tires. Who's correct?
wheel drive vehicle while driving at highway
speeds. Technician A says it could be bad U-
joints. Technician B says it could be out of
balance tires. Who's correct?