| ASE A-2 Automatic Transmission Practice Test Answers |
|---|
| 26.
Answer A is correct. A leaking clutch piston seal will cause a drop in pressure. Answer B is wrong. A stuck servo would not create a drop in pressure. Answer C is wrong. Technician A is correct. Answer D is wrong. Technician A is correct. Return |
| 27.
Answer A is wrong. They are similar to roller bearings. The cages hold balls instead of rollers and are capable of handling heavy radial loads. Answer B is wrong. Thrust washers control end-play. Answer C is Correct. Tapered roller bearings require a preloads. Answer D is wrong. Needle bearings or Torrington bearings are used between reduce friction between two rotating parts and are often used with thrust washers but would not require a preload. Return |
| 28.
Answer A. is correct. A binding U-joint is likely to damage both the bushing and the seal. Answer B is wrong. Output shaft end-play is not likely to damage the extension housing bushing. Answer C is wrong. Technician A is correct. Answer D is wrong. Technician A is correct. Return |
| 29.
Answer A is wrong. Both of these technicians are correct. The transmission fluid temperature sensor and the engine coolant temperature sensor are vital inputs for torque converter clutch operation. Answer B is wrong. The ECT inputs engine temperature information. The TCM adjusts TCC application with this necessary input. Answer C is correct. Both technicians are correct. Answer D is wrong. Both technicians are correct. Return |
| 30.
Answer A is wrong. Never use grease in an automatic transmission. It doesn't mix with the ATF. Use assembly lube. Answer B is correct. Technician B is correct. The friction bands and discs should be soaked at least 20 minutes before assembly. Answer C is wrong. Technician B is correct. Answer D is wrong. Technician B is correct.
|
ASE Study Guides Test Prep Practice
